How to Replace the Headband On Beats Studio 2 Headphones
The Beats Studio 2 wired and wireless headphones have a plastic arch that connects the two metal hinges that say "Studio" or "Wireless". This arch will frequently snap just above the metal hinges if put under too much strain. This article shows you how to replace that plastic arch.
If you would prefer to see a video tutorial on this repair, click Here. Or if the tool cost seems prohibitive for a one time repair and you would prefer that we complete this repair, check out our Repair Services to get your electronics fixed up by the pros.
Are you a business? We offer wholesale discounts on our repair services if you are sending numerous units in for repair or want to send us continuing batches of devices for repair on a regular basis. Contact our support team for more info Info@JoesGE.com (This email is only for wholesale inquiries, please contact Support@JoesGE.com for other inquiries).
Repair Difficulty: Easy
Time to complete: 15 Minutes
The tools and parts that you will need for this repair:
- New Headband
- T5 Screwdriver (To remove four screws)
- Pry Tool (Thin plastic screwdriver, a guitar pick, or the dull side of a butter knife can all work if you are careful).
1. Unscrew the screws from both sides of the hinges
There are four screws holding the headband into place. There are two on the bottom of each hinge. Fold the hinge inward to gain access to them.
2. Remove the broken headband
Once you have removed all four screws, your headband should slide out from the hinges. If part of the headband has broken off inside of the hinges, you should just be able to shake the hinge and have it fall out. Remember the orientation of the Beats logo on the top of the headband for when you install your new headband so that it is not backward.
***If you previously tried gluing the headphones back together, you might need to get some tweezers or pliers to remove any plastic bits that are stuck in the hinges. If you are unable to remove them due to glue, you might need to use something like Acetone to remove the glue which will also remove the paint on the hinge and can damage the wiring if you let it get on the headphones. If you would prefer, we can usually remove the plastic, or if it comes down to it, we can replace the hinge on your headphones if you send them in by following the steps Here.
3. Remove the headband cushion
Using your Pry Tool, start at one end of the rubber headband cushion and pry it away from the plastic headband. There is a plastic frame inside of the rubber cushion that uses snap connects to stay attached to the headband. Once you have one entire side removed from the headband, you should be able to easily remove the whole cushion from the headband.
4. Insert the new headband into the hinges
Just make sure that the Beats logo is facing forward. You should be able to read it regularly if you are looking at the front of the headphones.
5. Clip the headband cushion onto the headband
You will need to make sure that the large main wire is centered properly in the plastic headband before attaching the headband cushion. This can take some time so put on your favorite tunes and get it just right :)
Once it is centered, just apply pressure to the front and back of the cushion to snap it onto your headband. When done, it should look like this:
Those two rubber ends that are stick out all funny need to be put around the main wire, and tucked into the metal hinge. Fold one side of the headphones inward like so:
Then remove the other hinge from the headband and run the wire through the inside of the two rubber flaps on the end of the headband cushion, like so:
Once you have the wire tucked into the rubber, slide the hinge back onto the headband and headband cushion and insert both screws into that sides hinge.
Repeat this process for the other side of the headphones.
6. Now get back to jamming out 🎶
If you have any questions in regards to this repair, feel free to shoot us an email with some pictures and a description of your issue or question.