How to Replace PlayStation 4 PS4 Pro Top and Bottom Covers

Are the top or bottom plastic shells broken, cracked, or scuffed? If you want to make your console look new again, this is the guide for you!

 

If you would prefer to read a written repair guide, check that out below. Or if the tool cost seems prohibitive for a one time repair and you would prefer that we complete this repair for you, check out our Repair Catalog to see if we offer repair services for this device. 

 

Are you a business? We offer wholesale discounts on our repair services if you are sending numerous units in for repair or want to send us continuing batches of devices for repair on a regular basis. Contact our support team for more info Info@JoesGE.com (This email is only for wholesale inquiries, please contact Support@JoesGE.com for other inquiries).

_____________________________________________

 

Repair Difficulty: Easy   

Time to complete: 30 Minutes

 The tools and parts that you will need for this repair:

      1. Replacement Top or Bottom Shell
      2. T8 Screwdriver 

_____________________________________________

  

1. Remove the top housing

Lift from the center under the topmost ridge in the front of the console until it pops out of the connectors then, move to the corners and lift until you hear a pop. It might be easier to Watch This Part in the video. The cover should be loose and you can carefully slide it forward and off of the console.

Lift from the center

Lift from the corners.

 

2. Remove the Bottom Shell

There are 3 screws that you will need to remove from the back of the console. One of them is covered by a plastic cover. Remove the cover by pulling it up and away from the back of the console like so. 

Removing the latch door that covers the 3rd screw 

 

With the cover removed, you can unscrew the 3 black screws at the back of the console. 

Remove the 3 screws on the back of the Playstation

 

to remove the shell, lift up the left side of the case, then the right side, then the center. It would likely be very helpful to tune into the Video for this part as well. 

Popping up the left side of the top case

Popping up the right side of the top case

Lifting the top case in the center 

 

3. Re Install the Shells 

Reinstall the bottom plastic piece by setting it on the console a bit towards the front then slide it towards the back of the console while keeping the back part of the plastic elevated from the rest of the console. Once again, it might be helpful to see This Part in the Video

Sliding the bottom cover on from the front of the console to the back

 

Once the bottom shell is aligned vertically with the top shell, snap it into place until you hear a click on each corner and center of the back. 

Gently squeeze the two parts of the console together until you hear a click from each corner

 

Reinstall the 3 black screws into the back of the console. 

Reinstalling the 3 black screws at the back of the console

 

Reinstall the plastic hard drive slot cover on the back of the console. 

Reinstalling the hard drive slot cover at the back of the console 

 

Reinstall the top shell similarly to the bottom shell except you slide it forwards from the back of the console. After it is aligned, make sure all of the snap lock connectors are secured around the edge of the shell. 

Sliding the top cover into its place 

 

9. Get back to gaming 🕹 

 

 

If you have any questions in regards to this repair, feel free to shoot us an email or give us a call and we will do our best to reply to you as quickly as possible. Please inquire using our Repair Catalog if you are wondering how much a certain repair will cost. If you do not see your item in our repair catalog, it means that we do not offer repair services for it.

📧 Support@JoesGE.com

📞  360.362.1722

Next article PlayStation 4 PS4 Pro Hard drive HDD Replacement